Small Batch German Wheat- WG - Beer Recipe - Brewer's Friend

Brewer's Friend

Print

Small Batch German Wheat- WG

201 calories 19.2 g 12 oz
brewer logo
Beer Stats
Method: Extract
Style: Weissbier
Boil Time: 60 min
Batch Size: 2.5 gallons (fermentor volume)
Pre Boil Size: 3 gallons
Post Boil Size: 2.5 gallons
Pre Boil Gravity: 1.051 (recipe based estimate)
Post Boil Gravity: 1.061 (recipe based estimate)
Efficiency: 75% (steeping grains only)
Source: Peter McArthur
Hop Utilization: 94%
Calories: 201 calories (Per 12oz)
Carbs: 19.2 g (Per 12oz)
Created: Wednesday September 22nd 2021
1.061
1.013
6.2%
15.0
4.2
n/a
n/a
 
Fermentables
Amount Fermentable Cost PPG °L Bill %
2 lb Briess - DME Pilsen Light2 lb DME Pilsen Light 45 2 45.2%
2 lbs / $ 0.00
Steeping Grains
Amount Fermentable Cost PPG °L Bill %
1 lb Gladfield - Flaked Wheat (harraway's)1 lb Flaked Wheat (harraway's) 35.4 1.62 22.6%
1 lb Gladfield - Rolled Oats (harraway's)1 lb Rolled Oats (harraway's) 32.2 1.62 22.6%
0.18 lb Aromatic Malt0.175 lb Aromatic Malt 35 20 4%
0.25 lb Bestmalz - BEST Acidulated0.25 lb BEST Acidulated 35.9 2.81 5.6%
$ 0.00
 
Hops
Amount Variety Cost Type AA Use Time IBU Bill %
0.50 oz Barbe Rouge0.5 oz Barbe Rouge Hops Pellet 8.5 Boil 15 min 14.98 100%
0.50 oz / $ 0.00
 
Yeast
Fermentis - Safale-WB06
Amount:
1 Each
Cost:
Attenuation (avg):
78%
Flocculation:
Low
Optimum Temp:
59 - 75 °F
Starter:
No
Fermentation Temp:
-
Pitch Rate:
0.35 (M cells / ml / ° P) 50 B cells required
$ 0.00 Yeast Pitch Rate and Starter Calculator
Priming
CO2 Level: 4.04 Volumes
 
Target Water Profile
Balanced Profile
Ca+2 Mg+2 Na+ Cl- SO4-2 HCO3-
0 0 0 0 0 0
Quick Water Requirements
Water Gallons  Quarts
Heat water added to kettle (equipment estimates 4.17 g | 16.7 qt) 3.15 12.6  
Mash volume with grains (equipment estimates 4.17 g | 16.7 qt) 3.35 13.4  
Grain absorption losses (steeping) -0.3 -1.2  
Volume increase from sugar/extract (early additions) 0.15 0.6  
Pre boil volume (equipment estimates 4.02 g | 16.1 qt) 3 12  
Boil off losses -1.5 -6  
Hops absorption losses (first wort, boil, aroma) -0.02 -0.1  
Post boil volume 2.5 10  
Going into fermentor 2.5 10  
WARNING: Kettle losses > 2% detected which throw off OG calculation for extract/partial mash recipes in batch target 'fermentor' mode. Solution: Reduce kettle losses, misc losses and hops absorption in equipment profile, OR set batch target to 'kettle' and do a full wort boil. See batch target FAQ.    
Total: 3.15 12.6
Equipment Profile Used: System Default
 
Notes

Bring 3+ gals to a boil for 10min to boil off any chlorine.
Turn off burner.
Have Separate kettle
Steep Grains for 25 min at 165
A lot of water will be absorbed by the grains- Have a separate kettle of boiled water to bring back up to 3gals
Turn off burner and slowly add DME, mixing toughly.
Add 3 drops of Foam Control and stir
Bring to a boil and start timer
Add Hops and wort chiller at 15min
Remove from heat. Cool wort to 80 (about 20min)
Pour into Fermenter and add water to fill to 2.5
Add 2 drops of Foam Control to prevent krausen from bubbling into air-lock/tube.
TAKE OG READING
Aerate wort before pitching full packet of yeast
Sanitize scissors before pitching.

Pitch yeast at 80
OG:1.042
Warm Ferment- Keep close to 70-75
Heater set 73 ECO. Ambient Temp 75


FOR BLUEBERRY ADDITION:
Add 2lbs of blended blueberries that have been pasteurized and brought down to room temp to secondary vessel. Rack beer that is 5 days into fermentation in ON TOP of berries (ie add berries to secondary vessel first).
Will go through a "secondary" fermentation because of added sugars from blueberries but will also continue out primary fermentation.

Last Updated and Sharing
 
503
Views
0
Brews
Recipe QR Code
  • Public: Yup, Shared
  • Last Updated: 2021-09-27 06:29 UTC