Ten Fidy - Direct Clone

Target the mash ratio to be about 1.3 quarts of water to 1 pound of grain (2.7 kg/L), or 37% malt by weight.
Be sure to add in the volume of dead space liquid that is left in the mash tun after it is drained.
Mash the grains at 152 °F (67 °C) and hold at this temperature for 60 minutes. Raise the temperature of the grain bed to mash out at 168 °F (76 °C), add the rice hulls and vorlauf until the wort runs clear, then drain all the wort in the mash tun into your kettle.
There should be about 4 gallons (15 L) in your kettle with a gravity reading around 1.086.
Add an appropriate amount of dried malt extract if your gravity is too low.
Total boil time is 60 minutes, adding hops and the Whirfloc® tablet at the times indicated in the ingredients list.
At 0 minutes, turn off the heat and give the wort a stir for at least a minute and let it settle for 10 minutes.
The total volume in the kettle should be about 3.25 gallons (12.3 L). You can add some cold tap water to correct the volume if necessary. Chill and pitch the yeast, then heavily aerate the wort.
After 12 hours, hit the wort with a second dose of oxygen if possible. Ferment at 67 °F (19 °C) until you reach target gravity.
Transfer to a secondary vessel and drop the temperature to 54 °F (21 °C) and condition for a minimum of 3 weeks.
Keg and force carbonate or rack to a bottling bucket, add priming sugar, and bottle.
If the beer was aged in secondary more than a few months, add priming yeast such as Lallemand’s CBC-1 if bottle conditioning.