Anvil Brew Bucket

[TJM]

Morning, I have an Anvil 7.5 gal Stainless brew bucket. Problem is the black rubber/plastic bottom has come loose and will not reattach. Anyone know what type of epoxy or glue will work on this.
Thanks

 

[Hawkbox]

Is it on the inside or outside? I don't know the unit. Super glue should do the job if it's on the outside.

 

[Minbari]

JB weld makes an epoxie specifically designed for plastic. Have used it many times, works really well. 15 minute work time

 

[TJM]

Is it on the inside or outside? I don't know the unit. Super glue should do the job if it's on the outside.

Outside. It's on entire bottom and about 2" up the sides

 

[Hawkbox]

Then yeah superglue or JB Weld should do the trick.

 

[NorthWest Small Batch Brewing]

ya I have 2 and although I haven't had them fall off it's just a matter of time. I was going to suggest a bead of silicon. Looks like they are glued on with a glue stick. Actually ...hot glue gun could work too.

 

[TJM]

ya I have 2 and although I haven't had them fall off it's just a matter of time. I was going to suggest a bead of silicon. Looks like they are glued on with a glue stick. Actually ...hot glue gun could work too.

I used some Gorilla glue, very similar to E6000, that seems to be working

 

[Texas Ale Works]

E6000 was going to be my call