Wrong Temp Probe???
- Thread starter Reebman1
- Start date
You talking about plastic probes there reebman? I've had them stainless probes and plastic ones. My one point of advise is to check the probe cable length before buying you want at least 2 meters that's 12 feet in American I think
.
I use a plastic probe and its reading correct temp you know you can adjust for any differences or variations to temp in function 4 on STC? My other 2 bob is as long as it keeps the ferment temperature stable within half the degree you should be good no swings me matey. Cheers and brew on
.I use a plastic probe and its reading correct temp you know you can adjust for any differences or variations to temp in function 4 on STC? My other 2 bob is as long as it keeps the ferment temperature stable within half the degree you should be good no swings me matey.
Cheers and brew on
- Joined
- Nov 20, 2012
- Messages
- 8,851
- Reaction score
- 7,049
- Points
- 113
probs go bad easily, especially if they get wet , even the cheap stainless RTD goes bad so be careful, the wires get kinked also and short out
- Joined
- Jun 8, 2016
- Messages
- 42
- Reaction score
- 1
- Points
- 8
Jeffpn, I believe it's got the black plastic covered end instead of the metal end. Seems that I saw someone in a YouTube vid say to be sure to not get the "aquarium" style probe - referring to the black plastic. But for the life of me I'm not going to go trying to find which vid it was since I've watched probably all of them available on the subject! It doesn't seem like it would really make a difference...but what do I know? I'm still a baby in this hobby!
- Joined
- Jun 8, 2016
- Messages
- 42
- Reaction score
- 1
- Points
- 8
You talking about plastic probes there reebman? I've had them stainless probes and plastic ones. My one point of advise is to check the probe cable length before buying you want at least 2 meters that's 12 feet in American I think
I use a plastic probe and its reading correct temp you know you can adjust for any differences or variations to temp in function 4 on STC? My other 2 bob is as long as it keeps the ferment temperature stable within half the degree you should be good no swings me matey.
Well, it's a bit late for me to query the cable length, since I already have it purchased and in my grubby little paws! The one I got was close to 6 - 7 feet long and is sufficient for my setup...
- Joined
- Jun 8, 2016
- Messages
- 42
- Reaction score
- 1
- Points
- 8
Here it is (after several attempts to upload!)
Attachments
Same probe here that black plastic one all good in my book but then again I'm in your boat and sure ain't the guru home brew dude . If ya got another temp meter tape that to the fermentor and see if the temps are equal if not adjust temp as necessary.
That temp meter looks the goods here's mine
And that thing around the side of the carboy is that ya heat belt?
That's some sci fi NASA looking stuff wrapped around that fermentor better looking than my black heat belt and I see its split in two one section at the top and the other at the bottom of your carboy. Does it stick on too? My one doubles back on itself so to speak and you have to draw it tight or it just slips down or hangs loose doing nothing.
- Joined
- Jun 8, 2016
- Messages
- 42
- Reaction score
- 1
- Points
- 8
What would be wrong with soaking 3 or 4 feet of the probe wire in Star San and simply place it in the wort? Would ugly microbes 'crawl' down the wire from the part outside the ferment chamber making their way into the wort, thus tainting it?
