3/1/15 – Brewed by myself. Mash came in a little low at 144F so I added a quart of boiling water to bring it up to 146F. Added 4 grams of Gypsum and 1 gram of CaCl to the mash along with 4.7mL lactic acid, 1.5 grams of CaCl and 5.8 grams of Gypsum to the sparge. I used fly sparging for the first time and noticed an increase in my efficiency so I added half a gallon to bring the gravity down to my target pre-boil. Chilled to 68F and aerated with pure O2 for 45 seconds.
3/2/15 – Fermentation has started and is bubbling up through the air lock.
3/5/15 – Fermentation has calmed down, I’m assuming 3724 is starting to go dormant.
4/3/15 - Gravity down to 1.008. Racked beer to purged secondary for conditioning and to get the yeast cake free for the barrel.
4/23/15 - Placed in the chest freezer at 35F to cold crash.
4/25/15 - Bottled half as unblended Bernice with 85 grams of table sugar targeting 2.75 volumes of CO2. Racked the rest of the beer onto 3lbs 1 ounce of apricot puree to make it West Ashley-ish.
5/21/15 - Gravity down to 1.011 for the West Ashley half. I'll check again later to see if its stable.
6/29/15 - Bottled the West Ashley with 86 grams of table sugar.
7/27/15 - First tasting. I needed to add 3711
8/30/15 - First tasting of the West Ashley half.
About two days before I made a low gravity starter for my yeast (3724) to get it going and refresh it because it had been in my fridge for over a month. After a day I cold crashed then made a 1.040 starter to top up the original and added the dregs from a bottle of Bernice. My though process is that I wanted to refresh the dregs, but I wanted the Saison yeast to be proportionally the predominate yeast to do the bulk of the fermentation. Wyeast 3724 is notorious for stalling around 1.030, which should give the bugs plenty of food left to munch on until reaching terminal gravity. My experience in the past with 3724 is that it will continue to ferment; it just does it slowly, which is why I’m not concerned with the bacteria and Brett having too much food left over and souring too quickly. The only problem I experienced while brewing was just after I started the boil. I noticed the better bottle I bought a few days before was a ported version. So I added my hops in 15 minutes earlier than planned and ran to exchange it (no I didn’t leave the boil alone).
