Bananayum v2 - Beer Recipe - Brewer's Friend

Brewer's Friend

Print

Bananayum v2

187 calories 22.2 g 12 oz
Beer Stats
Method: All Grain
Style: Weissbier
Boil Time: 120 min
Batch Size: 5.6 gallons (ending kettle volume)
Pre Boil Size: 8 gallons
Pre Boil Gravity: 1.040 (recipe based estimate)
Efficiency: 68% (ending kettle)
Calories: 187 calories (Per 12oz)
Carbs: 22.2 g (Per 12oz)
Created: Friday January 22nd 2021
1.056
1.018
5.1%
43.3
4.5
5.7
33.17
 
Fermentables
Amount Fermentable Cost PPG °L Bill %
5 lb Weyermann - Barke Pilsner Malt5 lb Barke Pilsner Malt 1.23 / lb
6.14
37.03 1.75 38.5%
7 lb American - White Wheat7 lb White Wheat 1.75 / lb
12.25
40 2.8 53.8%
1 lb Rice Hulls1 lb Rice Hulls 0.95 / lb
0.95
0 0 7.7%
13 lbs / 19.34
 
Hops
Amount Variety Cost Type AA Use Time IBU Bill %
0.40 oz Simcoe (12.7 AA)0.4 oz Simcoe (12.7 AA) Hops 1.95 / oz
0.78
Pellet 12.7 Boil at 203 °F 30 min 14.56 10%
0.40 oz Sultana0.4 oz Sultana Hops 2.25 / oz
0.90
Pellet 14.5 Boil at 203 °F 30 min 16.62 10%
0.60 oz Simcoe (12.7 AA)0.6 oz Simcoe (12.7 AA) Hops Pellet 12.7 Boil at 203 °F 5 min 5.66 15%
0.60 oz Sultana0.6 oz Sultana Hops Pellet 14.5 Boil at 203 °F 5 min 6.47 15%
1 oz Simcoe (12.7 AA)1 oz Simcoe (12.7 AA) Hops 1.95 / oz
1.95
Pellet 12.7 Boil at 203 °F 0 min 25%
1 oz Sultana1 oz Sultana Hops 2.25 / oz
2.25
Pellet 14.5 Boil at 203 °F 0 min 25%
4 oz / 5.88
 
Other Ingredients
Amount Name Cost Type Use Time
2.50 g Calcium Chloride (anhydrous) Water Agt Mash 1 hr.
1 g Epsom Salt Water Agt Mash 1 hr.
2.50 g Gypsum Water Agt Mash 1 hr.
1 g Table Salt Water Agt Mash 1 hr.
5 g Fermaid O Other Boil 10 min.
 
Yeast
White Labs - Hefeweizen Ale Yeast WLP300
Amount:
1 Each
Cost:
7.95 / each
7.95
Attenuation (custom):
70%
Flocculation:
Low
Optimum Temp:
68 - 72 °F
Starter:
Yes
Fermentation Temp:
73 °F
Pitch Rate:
0.5 (M cells / ml / ° P) 146 B cells required
7.95 Yeast Pitch Rate and Starter Calculator
Priming
Method: co2       CO2 Level: 2.47 Volumes
 
Target Water Profile
Balanced Profile
Ca+2 Mg+2 Na+ Cl- SO4-2 HCO3-
47.1 2.6 10.4 66.7 54.5 0
Mash Chemistry and Brewing Water Calculator
 
Mash Guidelines
Amount Description Type Start Temp Target Temp Time
5.5 gal Temperature 167 °F 155 °F 60 min
4 gal Sparge 194 °F 168 °F 10 min
Starting Mash Thickness: 1.5 qt/lb
Quick Water Requirements
Water Gallons  Quarts
Strike water volume at mash thickness of 1.5 qt/lb 4.88 19.5  
Mash volume with grains 5.92 23.7  
Grain absorption losses -1.63 -6.5  
Remaining sparge water volume 5 20  
Mash Lauter Tun losses -0.25 -1  
Pre boil volume (equipment estimates 8.75 g | 35 qt) 8 32  
Boil off losses -3 -12  
Hops absorption losses (first wort, boil, aroma) -0.15 -0.6  
Post boil volume (equipment estimates 4.85 g | 19.4 qt) 5.6 22.4  
Estimated amount in fermentor 5.6 22.4  
Total: 9.88 39.5
Equipment Profile Used: System Default
 
Notes

Tasting notes: minimal bubblegum/banana esters compared to v1, probably because fermentation temps were actually in line with recommended instead of running above 80degF. Next time should build a starter and pitch at 80degF to try to get more of those esters/phenols. Could also try a warming blanket or turn up one of the new baseboard heaters to replicate. Is a bit bitter/astringent on the aftertaste, should tone it down on the hops next time, either stick with the 1oz each of simcoe/sultana or perhaps use a more traditional noble hop for comparison.

Initial mash pH was 5.7 at 147deg F. At 25 mins into mash, begin raising temp to 162deg F for second rest. Next time might need a few ounces of acid malt in addition to the brewing salts to get the pH lower on this smaller version.

Need to use at least 6 gallons of water if not 6.5 for the mash, the rice hulls soak up a lot of water. Use less water on the sparge--came out with 8 gallons of water pre boil which necessitated a longer boil time (which is probably for the better, unless you're impatient).

From "Weihenstphan-Style Hefeweissbier" CB&B:

Mill the grains and mash in at 113°F (45°C), then follow the steps below for this double-decoction mash:

Pull about one-third of the mash and heat it to 162°F (72°C), rest 20 minutes. Then heat it to 203°F (95°C), rest another 20 minutes.
Meanwhile, heat the rest of the mash to 131°F (55°C) and hold until first decoction is complete.

Reunite the mash to bring it to about 149°F (65°C). Rest 40 minutes.
For the second decoction, pull about one-third of the mash and heat it to 162°F (72°C), rest 20 minutes. Then heat it to 203°F (95°) and rest 15 minutes.
Reunite the mash to bring it to about 162°F (72°C).
Heat the mash to 172°F (78°C) and mash out.

Lauter and sparge to get about 6.6 gallons (25 liters) of wort—or more, depending on your evaporation rate. Boil 70 minutes, following the hops schedule. After the boil, chill to 66°F (19°C), aerate the wort, and pitch the yeast. Ferment at 68°F (20°C) for 4 days. Optionally, if possible, add 1–2 quarts (946 ml–1.9 l) of fresh, unfermented wort (known as speise). Then ferment another 4 days at 68–72°F (20–22°C) before cooling to 41°F (5°C) for 2 weeks. Package and carbonate to about 3.5 volumes.



Simcoe: Specific aroma descriptors include passion fruit, pine, berry and earth characteristic

Sultana (formerly-Denali/Nuggetzilla/EXP 06277): With pineapple, pine and bright citrus notes, Sultana is sure to make "one hell of an IPA!"

Try a Ferulic Acid Rest next time. See here for details: https://learn.beerandbrewing.com/courses/take/advanced-all-grain-methods/texts/8160912-ferulic-acid-rest

Wheat needs to be milled separately from munich and 2row.

OG was 1.042 with 55% efficiency which is really not idea.

FG was 1.013 which is 71% attenuation for a ABV of 3.84%.

Goal ABV was between 5-5.5%, see notes above for ideas on increasing efficiency next time.

Last Updated and Sharing
 
453
Views
0
Brews
Recipe QR Code
  • Public: Yup, Shared
  • Last Updated: 2021-02-17 00:03 UTC